Entry Data Receive; How To Make Soft Switch Setting; Cutter Aging - Sharp FO-71 Service Manual

FO-71RA
FO-51RA

3. 12. Entry data receive

In this mode, the registered data sent from the other machine is re-
ceived and the received data is registered in the machine. When this
mode is used for receiving, the other machine must be in the entry data
send mode.
After receiving is completed, the machine prints the following lists:
1. Telephone list data
2. Passcode No. (only for the type with polling function)
3. Soft switch list
4. Junk fax number list
5. Timer reservation data (only model which timer communication is
possible)

4. How to make soft switch setting

To enter the soft switch mode, press the following key entries in se-
quence.
Press FUNCTION
DATA No.
S F T SW-A1 = 0 0 0 0 0 0 0 0
S F T SW-A1 = 1 0 0 0 0 0 0 0
S F T SW-A1 = 1 0 0 0 0 0 0 0
S F T SW-A1 = 1 0 0 0 0 0 0 0
S F T SW-A1 = 1 0 0 0 0 0 0 0
S F T SW-A2 = 0 0 0 0 0 0 0 0
S F T SW-K1 = 0 0 0 0 0 0 0 0
9 8
1 2 3 4 5 6 7 8
The soft switch mode is terminated.
3. 13. Cutter aging (FO-71 only)
This mode is used to consecutively cut the recording paper about 10
mm long and to display the number of cutting times.
(The number of cutting times is cumulatively counted unless you ex-
ecute the memory clear or power off.)
The operation is stopped in the following cases:
1. Hold down the stop key. (The cutter aging is stopped.)
2. No recording paper. (The cut operation is stopped.)
3. Recording paper jam. (The cut operation is stopped.)
7 START
Press FUNCTION key.
Press
Press
Bit1 - 8 are set.
Press START
Soft SW-A2 - SW-K1 are set.
To finish the settings halfway between
SW-A1 and SW-K1, press the STOP
key. In this case, the setting being done
to the SW No. on display will be nullified
while settings done to the preceding
SW No. remain in effect.
When the COPY key is pressed, the
contents of soft switches are printed.
2 – 4
START
key.
key.
key during setting.