Shaft & Bearing Assembly Replacement - Metcalfe EP10 Service Manual

Shaft & Bearing Assembly Replacement
1. Turn the machine upside down and fit the bottom bearing into the housing from underneath the
machine, ensuring it is flush with the base of the peeler.
2. Stand the machine back upright and fit the first bearing along with the bearing spacing collar onto
the shaft.
3. Fit the second bearing along with the bearing spacing collar on to the shaft, and fit shaft through
the first bearing, from inside the unit. Tap the shaft gently into place with a mallet, making sure that
the bearing is fitted properly (the bearing should be flush with the casting or just below it).
4. Turn the machine upside down and refit the bearing retaining washer, securing it with the three
screws.
5. Fit the deflector disc to the shaft (turned down outer edge facing downwards), securing with the
silicon adhesive supplied. Allow to dry for 24 hours.
6. Turn the machine upside down and refit the pulley and belt.
7. Stand the machine back upright and fit the oil seal over the shaft, so that it is flush with the
deflector disc.
8. Re-screw the sweeper and fit the rotor plate back into place, securing with the rotor plate fixing
screw.
9. Refit the top casting and rubber lid.
11