Timer; Managing Camera Units - Panasonic KX-HN3051C Operating Instructions Manual

Programming

Timer

The timer can be used to play sound from the
monitor unit after the specified number of
hours has passed. The timer can be set to
sound once or repeat at specified intervals.
1
MMENUN
2
MbN: "Timer" a MOKN
3
MbN: Select "Once" or "Repeat". a
MOKN
4
MbN: Specify when the timer is set for. a
MOKN a MMENUN
Note:
R Timers play for 1 minute. Press MOKN to
stop a timer. Press and hold MOKN for
5 seconds to stop timers from repeating.
R If the monitor unit is turned off after setting
a timer:
– "Once": The timer will be cancelled.
– "Repeat": The timer will be played once
the specified time has passed from when
the monitor was turned on again.

Managing camera units

Up to 3 additional camera units can be
registered to the monitor unit.
Registering a camera unit
Additional camera units can be registered to
the monitor unit.
Monitor unit:
1
MMENUN
2
MbN: "Camera Management" a MOKN
3
MbN: "Add Camera" a MOKN
R An operation guide is displayed. Press
MOKN to continue.
R Complete the following step within
90 seconds.
Camera unit:
1
Press and hold M
the LED indicator starts blinking.
For assistance, visit www.panasonic.ca/english/support
28
HN3051C̲(en̲en)̲0228̲ver.040.pdf 28
Note:
R A message is displayed on the monitor unit
Resetting the settings for a
camera unit
The camera unit settings saved on a monitor
unit can be reset.
Note:
R All camera unit settings except for
R Settings for all camera units registered to
1
2
3
4
Cancelling a camera unit
You can cancel camera units that are no
longer needed.
Note:
R Only the currently connected camera unit is
1
2
3
4
N for 3 seconds until
to show if the registration was successful or
not, and a beep sounds.
registration settings are reset.
the monitor unit are reset.
MMENUN
MbN: "Camera Management" a MOKN
MbN: "Reset" a MOKN
N: "Yes" a MOKN
M
R A beep sounds from the monitor unit
when resetting is completed.
cancelled. To cancel other camera units,
select the displayed camera unit (page 21)
and then cancel that camera unit.
MMENUN
MbN: "Camera Management" a MOKN
MbN: "Delete Camera" a MOKN
N: "Yes" a MOKN
M
2018/02/28 16:25:29