Related Manuals for Dreame Bot L10 Pro
Summary of Contents for Dreame Bot L10 Pro
- Page 1 The expert for robots in your home With one click to the online shop myRobotcenter.eu myRobotcenter.co.uk myRobotcenter...
- Page 2 项目名称 料号 P2029欧版 05-2029-018-01-000 版本号 V2.0 材质工艺要求： 封面157g双铜 材质： 设计时间 内文105g哑粉纸 胶装 2020/11/20 CMYK 四色印刷 颜色及专色： 物料名称 210mm*140mm 说明书 尺寸要求： 设计师 何启慧 审核 批准 注：此页面非印刷内容...
- Page 3 • The word "dreame" is the abbreviation of Dreame Technology Co., Ltd. and its subsidiaries in China. It is the transliteration of the company's Chinese name " 追觅 ", which means striving for excellence in every endeavor and reflects the company's vision of continuous pursuit, exploration and search in technology.
-
Page 4: Safety Information
This product contains batteries that can only be replaced by qualified technicians or after-sales service. Hereby, Dreame Trading（Tianjin）Co., Ltd. declares that the radio equipment type RLS5L is in compliance with Directive 2014/53/ EU. The full text of the EU declaration of conformity is available at the following internet address: www.dreame-technology.com... -
Page 5: Product Overview
Product Overview Product Overview Accessories Robot Spot Clean Button ·Press briefly to begin Spot Clean Mode Power/Clean Button ·Press and hold for 3 seconds ·Press to begin cleaning after the robot is powered on Status Indicator ·White: Cleaning or cleanup is completed Charging Dock Cleaning Tool Power Cord... - Page 6 Product Overview Product Overview Robot Dust Bin Mopping Module Cliff Sensor Omnidirectional Wheel Reset Button · Press and hold for 3 seconds to restore the robot to factory settings Charging Contacts Charging Contacts Water Inlet Bin Clip Side Brush Wi-Fi Indicator Water Tank Bin Cover Cliff Sensor...
-
Page 7: Preparation Before Use
Clearing Home Environment Preparation Before Use 1. Remove the protective matter 3. Place the charging dock on the level ground against the wall and connect it to a power outlet ＞ 0.5 m ＞ 0.5 m ＞ 1.5 m Note: •... -
Page 8: How To Use
" in the top right corner, scan the QR code, • When the robot is paused, placing it onto the charging dock will end the add "Dreame Bot L10 Pro", and follow the prompts to finish the • current cleaning task. - Page 9 How to Use How to Use 6. Spot Clean mode 7. Scheduled Cleaning 9. Use the Mopping Function 3) Align the mopping module as indicated by the arrow, then slide it It is recommended that all floors are vacuumed at least three times into the back of the robot until it clicks into place.
-
Page 10: Routine Maintenance
Routine Maintenance Routine Maintenance Clean the Dust Bin and Filter Clean the Mopping Module 1. Open the robot cover, then press the dust bin clip to remove the 3. Remove the filter and tap its basket gently. 1. Press the two release clips on the side of water tank, remove the 3. - Page 11 Routine Maintenance Routine Maintenance Note: Wet cloths can damage sensitive elements within the robot and charging dock. Please use dry rags for cleaning. Clean the Main Brush Clean the Side Brush Press the brush guard clips inwards to remove the brush guard and Pull out the side brushes and use the included cleaning tool to lift the brush out of the robot.
- Page 12 Problem Type Solution Problem Type Solution Battery level is low. Recharge the robot at the charging dock, then try again. Robot does not turn on The ambient temperature is too low (below 0° C) or too high (above 40° C). The operating temperature of the Does leaving the robot on the Leaving the robot on the charging dock after it's fully charged consumes very little electricity and helps robot is 0°...
-
Page 13: Specifications
Specifications Robot Charging Dock Model RLS5L Model RCS0 Battery 5200 mAh (Battery Nominal Capacity) Rated Input 100-240 V ~ 50/60 Hz 0.5 A Wireless Wi-Fi IEEE 802.11b/g/n 2.4GHz Rated Output 19.8 V Connectivity Under normal use of condition, this equipment should be kept a Rated Voltage 14.4 V separation distance of at least 20cm between the antenna and the...
Need help?
Do you have a question about the Bot L10 Pro and is the answer not in the manual?
Questions and answers