Sealey VS704.V2 Instructions

Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these
instructions and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL
REQUIREMENTS, WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE
PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY
AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
1.2 GENERAL SAFETY
 WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are
adhered to when using this equipment.
 WARNING! Always wear approved eye protection when using the seal driver. Failure to do so may result
in serious injury. Normal spectacles are not adequate protection.
 Familiarise yourself with the specific applications and limitations of the seal driver, as well as any potential
hazards.
 If unsure of the applications or limitations of the seal driver contact your supplier.
 Ensure that the seal driver is the correct tool for the task. DO NOT use the seal driver for any purpose
other than that for which it is designed.
 Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will
invalidate the warranty.
 Ensure that the workpiece is stable and that there is adequate lighting.
 Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.
 Use the correct size and type of hammer for the task. The recommended diameter of hammer face is
10mm larger than tool head. Check that the hammer handle is in good order and is firmly secure in the
hammer head. Note that for seal installation a soft-faced hammer should be adequate and will be less
likely to damage the tool.
 Make sure that the face of the hammer and the head of the tool are clean and free from grease, oil, etc.
 Position the tool so that it is struck away from your body.
 Strike the driver squarely on the head - DO NOT hit the tool off centre or at an angle (fig.1).
 DO NOT use the seal driver if it is bent, chipped, has a mushroom head or is otherwise damaged (fig.2).
 DO NOT strike the side of the seal driver body (fig.3).
 Keep children and unauthorised persons away from the working area.
 DO NOT use seal driver if any parts are damaged or missing as this may cause failure and/or personal
injury.
 DO NOT use the seal driver when you are tired, under the influence of alcohol, drugs or intoxicating
medication.
fig. 1
INSTRUCTIONS FOR:
SEAL DRIVER SET - 16 PIECE
VS704.V2
MODEL NO:
fig. 2 fig. 3
VS704.V2 Issue: 1 - 17/07/08