Maintenance - Makita XDT11 Instruction Manual

Hide thumbs Also See for XDT11:
Table of Contents

Advertisement

To insert the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Always insert it all the way until it locks in
place with a little click. If you can see the red part on
the upper side of the button, it is not locked completely.
Insert it fully until the red part cannot be seen. If not, it
may accidentally fall out of the tool, causing injury to
you or someone around you.
Do not use force when inserting the battery cartridge. If
the cartridge does not slide in easily, it is not being
inserted correctly.
Lighting up the bulb (Fig. 2)
CAUTION:
Do not look in the light or see the source of light
directly.
This tool has function that bulb light goes out at low
voltage. At this time, recharge the battery cartridge.
Push the switch to light up the bulb. To turn off, push the
switch again.
The following tables indicate the operating time on a
single charge.
Battery
Model
Voltage
cartridge
BL1415
BL1415N
DML145
14.4V
BL1430
BL1440
BL1815
BL1815N
DML185
18V
BL1820
BL1830
BL1840
Head angle (Fig. 2)
The head angle can be adjusted in four stages. Adjust as
desired.
ASSEMBLY
Replacing bulb (Fig. 3 & 4)
CAUTION:
The bulb is very hot immediately after operation. Wait until
the bulb cools off before attempting to replace it.
First, turn the ring counterclockwise and remove the
reflector. Then replace the bulb.
Shoulder strap (Fig. 5)
Install the strap on the tool.

MAINTENANCE

To maintain product safety and reliability, repairs,
maintenance or adjustment should be carried out by a
Makita Authorized Service Center.
ACCESSORIES
CAUTION:
These accessories or attachments are recommended for
use with your Makita tool specified in this manual. The
use of any other accessories or attachments might
present a risk of injury to persons. The accessories or
attachments should be used only in the proper and
intended manner.
Bulb set (2 pcs.)
Shoulder strap
Various type of Makita genuine batteries and chargers
Operating
time
Approx.
100 min
Approx.
130 min
Approx.
220 min
Approx.
340 min
Approx.
110 min
Approx.
130 min
Approx.
180 min
Approx.
240 min
Approx.
340 min
5

Advertisement

Table of Contents
loading

Table of Contents