Husqvarna DM220 Workshop Manual page 11

5
GEAR HOUSING – INTERMEDIATE SHAFT
510 22 11-01 Type B
Adjusting the slip clutch
Mount the intermediate shaft's helical
drive wheel in the service tool. Tighten
the service tool in a vice.
Start by tightening the nut to the mecha-
–
nical stop position. Check the torque
with a torque wrench and socket -article
number 5102211-01
The clutch must have a slipping torque
of at least 16 Nm. If the value is not
reached, the spring and friction washers
+
must be replaced.
If the torque exceeds 16Nm, gradually
unscrew the nut and check with the tor-
que wrench.
Torque: 16 Nm, 12 lbf ft
11