Reset Heater - Sharper Image RISE 20H Owner's Manual

RESET HEATER

Your heater has a multilevel safety shut-off system designed to prevent
overheating. Overheating may occur when the inlets or outlet are blocked. If
this happens, the safety shut-off system cuts power to the heater and you must
manually reset the heater.
1. Power heater off, then unplug power cord.
2. Remove any obstructions.
3. Wait 5–10 minutes, allowing heater to cool down.
4. Plug in power cord and place heater in desired position.
5. Press Power button On. Your Sharper Image Heater should now
function normally.
If the heater and other electrical products suddenly stop working at the same
time, your home circuit breaker or fuse may have tripped due to an overload of
power. Consider only running your heater on the "low" setting, only running one
heater at once and unplugging all other electrical products while running the
heater, and/or hiring an electrician to install an additional circuit to your home's
electrical system.
NOTE: If the safety shut-off system repeatedly shuts off your heater or if it will
not reset after following the above procedure, call Sharper Image Consumer
Services Department toll-free at 833-800-8669.
English 15