Philips Freeman 7525 Service Manual page 11

12. Press OK Key & wait up to display the E2P Upgrade Completed message.
13. If message is "Operation not allowed", press Back key on remote control & confirm M mode is
ON. If M mode is OFF, do ON.
14. If message is "Device not found", insert USB properly and then do E2P upgrade.
15. Press EXIT key on remote.
16. Wait for few seconds. Now mains OFF & ON the TV set.
17. Press ATV Menu on Remote Control. Select Setup > Software Settings > Check e2p version
b) SW installation using USB :-
steps for Software upgrading of .sdl file by USB:
1. Crete "PHILIPS" folder in USB & Copy the .sdl file in Philips folder.
2. Connect the USB in the TV.
3. During Bootup, when first LED will glow then OFF or Color Change then immediately ,
press the Remote control keys sequence as-
Power-> UP Navigation-> Down Navigation-> Down Navigation.
4. Wait few sec TV will powered on . If key sequence is properly detected by TV at start then
below screen will appear & SW loading will be started: