Related Manuals for Petsafe PIF-275-19
Summary of Contents for Petsafe PIF-275-19
- Page 1 Product Manual PIF-275-19 Wireless Pet Containment System Receiver Collar Please read this entire product manual before beginning.
- Page 2 If you have any questions, please don’t hesitate to contact us. Hereinafter Radio Systems Corporation, Radio Systems PetSafe Europe Ltd., Radio Systems Australia Pty Ltd. and any other affiliate or brand of Radio Systems Corporation may be referred to collectively as “We” or “Us.”...
-
Page 3: Important Safety Information
CAUTION, used with the safety alert symbol, indicates a hazardous situation which, if not avoided, could result in minor or moderate injury. CAUTION, used without the safety alert symbol, indicates a hazardous situation which, if not avoided, could result in harm to your pet. petsafe.com... - Page 4 When batteries are stored or disposed, they must be protected from shorting. Dispose of used batteries properly. • This PetSafe Wireless Pet Containment System is NOT a solid barrier. ®...
- Page 5 Therefore, if you have reason to believe that your pet may pose a danger to others or harm himself if he is not kept from crossing the boundaries, you should NOT rely solely upon the PetSafe Wireless Pet Containment System to confine your pet. Radio ®...
- Page 6 • You may need to trim the hair in the area of the contact points. However, never shave your pet’s neck; this may lead to a rash or infection. • Never connect a leash to a collar with contact points. It will cause excessive pressure on the contact points.
- Page 7 • Always remove your pet’s receiver collar before performing any transmitter testing or adjustments. This will prevent unintended corrections. • The boundary zone must be tested whenever an adjustment is made to the fence transmitter setting to prevent unintended corrections to your pet. petsafe.com...
-
Page 8: How The System Works
How the System Works The PetSafe Wireless Pet Containment System has been proven safe, ® comfortable, and effective for pets over 8 lb. The system works by transmitting a radio signal up to 90 feet in all directions. You temporarily define the pet area with boundary flags for a visual aid in training your pet. -
Page 9: Prepare The Receiver Collar
Your receiver collar comes with short contact points. Use the long contact points for pets with long or thick hair. Tighten the contact points using the test light tool (A) one-half turn beyond finger tight. Check the tightness weekly. petsafe.com... - Page 10 (C). DO NOT attempt to cut into or pry open the battery. Be sure to discard the used battery properly. A replacement PetSafe battery (RFA-67) can be found at many retailers. ® Contact the Customer Care Center or visit our web site at www.petsafe.com to locate a retailer near you. 1-800-732-2677...
- Page 11 5. After setting the static correction level, replace the cover to protect the correction level button. The static correction levels increase in strength from 1 to 6. Pushing the correction level button while the receiver collar is on level 6 will cause the receiver collar petsafe.com...
-
Page 12: Battery Contact Verification
to revert to level 1. Refer to the Function and Response Table to choose the static correction level that best fits your pet. The receiver indicator light acts as a low battery indicator. The light will flash every 4 to 5 seconds when battery replacement is required. - Page 13 If your pet enters the boundary zone or continues anywhere beyond the pet area, this feature limits the static correction duration to 30 seconds. In the unlikely event that your pet leaves the pet area, he will not receive a static correction upon return to the pet area. petsafe.com...
-
Page 14: Fit The Receiver Collar
Fit the Receiver Collar Important: The proper fit and placement of your receiver collar is important for effective training. The contact points must have direct contact with your pet’s skin on the underside of his neck. See important safety information on pages 3-7. To assure a proper fit, please follow these steps: 1. - Page 15 Remove the receiver collar from your pet and cut off the excess. c. Before placing the receiver collar back onto your pet, seal the edge of the cut collar by applying a flame along the frayed edge. 8. Put battery in receiver collar. petsafe.com...
-
Page 16: To Re-Thread The Collar
To Re-Thread the Collar Slide The slide buckle prevents the collar from Buckle becoming loose around your pet’s neck. Ridges The ridges must be facing up; the collar will slip if it is not properly threaded. Slide To loosen: Slide the strap through the Buckle Fasten Slide and Fasten Buckles and pull down. -
Page 17: Taking Your Pet Out Of The Pet Area
You may initially need to convince your pet to leave the pet area with a food treat and lots of praise. NOTE: You may also carry your pet out of the pet area. petsafe.com... -
Page 18: Troubleshooting
Please refer to your PetSafe Wireless Pet Containment System Product ® Manual for a complete list of Troubleshooting or visit www.petsafe.com Troubleshooting The receiver collar • Check that the transmitter is plugged into a is not beeping or working 120-volt outlet, turned on, the power... - Page 19 • If the test light flashes, check the fit of the static correction. receiver collar. • Trim your pet’s fur where the contact points touch the neck and/or switch to the longer contact points. • Increase the static correction level. • Repeat training steps to reinforce training. petsafe.com...
- Page 20 Troubleshooting My pet reacts • Lower the static correction level. strongly to the static • Make sure you are in control of the situation correction and has when your pet receives his first static correction become fearful. (have him on a leash attached to a separate, non-metallic collar) and lead him into the pet area and praise him.
-
Page 21: Test Light Instructions
(J). Save Test Light for future testing. NOTE: If the Test Light does not flash, install a new battery and re-test. If Test Light still does not flash, Area contact the Customer Care Center. petsafe.com... -
Page 22: Terms Of Use And Limitation Of Liability
Terms of Use and Limitation of Liability 1. Terms of Use This Product is offered to you conditioned upon your acceptance without modification of the terms, conditions and notices contained herein. Usage of this Product implies acceptance of all such terms, conditions, and notices. - Page 23 NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful petsafe.com...
- Page 24 interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a specific installation.
-
Page 25: Customer Care International
Monday – Friday 8 AM – 8 PM / Saturday 9 AM – 5 PM Australia—Tel: 1800 786 608 Monday – Friday 8:30 AM – 5 PM New Zealand—Tel: 0800 543 054 Monday – Friday 10:30 AM – 7 PM petsafe.com... -
Page 26: Important Recycling Advice
Customer Care Center to receive instructions on proper disposal of the unit. Please do not dispose of the unit in household or municipal waste. For a listing of Customer Care Center telephone numbers in your area, visit our website at petsafe.com. 1-800-732-2677... -
Page 27: Perchlorate Battery
Perchlorate Battery Perchlorate Material—special handling may apply. See www.dtsc.ca.gov/hazardouswaste/perchlorate. petsafe.com... - Page 28 Radio Systems Corporation 10427 PetSafe Way Knoxville, TN 37932 +1 (800) 732-2677 petsafe.com For a list of patents protecting this product, please visit www.radiosystemscorporation.com/patents. 400-1423/2 2020 Radio Systems Corporation ©...
Need help?
Do you have a question about the PIF-275-19 and is the answer not in the manual?
Questions and answers