Remote Control Instructions - Emerson QUIET KOOL EARC6RE1 Operating Instructions Manual

REMOTE CONTROL
1.Power: To turn the air conditioner on and off.
2.Cool: Press the COOL button to select COOL mode.
3. and : Use these buttons on the control panel
and remote to increase or decrease the Set
Temperature or Timer.
Temperature range: 61℉~88℉ or 16℃~31℃.
.
4. Sleep: Press the SLEEP button, the Sleep
Light will be on after 10 seconds, and all the lights will
be off. In SLEEP mode, the air-conditioner will
automatically adjust the temperature and fan
speed to make the room more comfortable during
the night. The set temperature will automatically raise by
1℃ every 30-60 minutes and at most change six times
until the set temperature is
Battery Size: AAA
NOTE: Do not mix old and new batteries or different types
of AAA batteries.
28℃.
5. Timer Button: Use these buttons on the control
panel and remote to set the Timer.
Timer Off: The timed stop is programmed by pressing
the TIMER button. Set the rest time by pressing the
∧ ∨
button or until the desired time is reached; then
press TIMER button again to confirm your setting.
Timer On: When the unit is off, press TIMER button a
first time; set the temperature by pressing the
.
button Press TIMER button a second time, set the start
time by pressing the button
button a third time to confirm the setting, then the time
remaining until the unit auto-starts will appear on the
display.
Note: The air conditioner can be set to automatically turn
off or on in a delay of 0.5-24 hours. Each press of the
or "∨"
button will increase or decrease the timer. The
timer can be set in 0.5 hours increments up to 10 hours,
and in 1 hour increments for 10 hours or more. The SET
light will turn on while setting. To cancel the setting, press
the TIMER button again.
6. Auto Mode: Press AUTO MODE button
AUTO mode directly. In this mode the fan speed and the
temperature are set automatically according to the room
temperature (tested by the built-in temperature sensor).
7. Fan Speed: Press the FAN SPEED button to
choose the fan speed options. You can choose Hi, Med,
Lo or auto speed in COOL mode and choose Hi, Med, Lo
in FAN mode.
8. Display: Press the DISPLAY button, to switch off/on
all lights or LED display.
9. Eco Button: When the unit is in ECO mode, the
light will turn on. In ECO mode, the unit will turn off once the
room is cooled to the set temperature. The fan will also be
off at this point. The unit will turn back on when the room
temperature rises above the set temperature. Before the
compressor stars, the fan will run 10 minutes – stop 20
seconds – and again, to save energy.
10. Fan Only: Press the Fan Only button to select FAN
ONLY mode.
∧
or
∧ ∨
or . Press TIMER
to select
∨
"∧"