Advertisement
Quick Links
Lincoln Quicklub System Operation
and Troubleshooting Guide
System Operation
The key components of the Quicklub system are:
1. Pump with integrated system control and monitoring
2. Proximity Switch
3. Divider valve network consisting of a Primary Valve and Secondary Valves
4. A lubrication event is initiated by actuating the pump via the integrated controller based
on a preset "pause time" or time between lubrication events.
5. The Pump dispenses lubricant to the primary divider valve
6. The Primary Valve distributes the lubricant to the secondary valves
7. The Secondary Valves distribute and dispense lubricant to the lubrication points.
8. Lubricant flow through the divider valves actuates the Proximity Switch, which sends a
signal back to the integrated controller/monitor acknowledging proper system operation
and turning off the pump.
9. The controller now begins countdown for the next lubrication event.
Advertisement
Related Manuals for Lincoln Quicklub Series
Summary of Contents for Lincoln Quicklub Series
- Page 1 Lincoln Quicklub System Operation and Troubleshooting Guide System Operation The key components of the Quicklub system are: 1. Pump with integrated system control and monitoring 2. Proximity Switch 3. Divider valve network consisting of a Primary Valve and Secondary Valves 4.
- Page 2 Pump with Cycle Controller Indicator Pin / Monitor Hose Primary Valve Lube Point Tubing R3 Valve R2 Valve Secondary Valves...
-
Page 3: System Troubleshooting
System Troubleshooting The integrated controller can diagnose certain faults and provides an indication of which fault it is via a flashing indicator light. Here are a list of the faults and the fault indication: Fault indication light and pushbutton Fault Indication Malfunction A: LED flashes continuously for one second Drive motor defective or electrical line is damaged (see causes... - Page 4 A: Fault: The pump motor does not run Cause: Remedy: Voltage supply interrupted Check the voltage supply to the pump. If necessary, eliminate the cause of the fault. Voltage supply to the printed-circuit board is Check the line leading from the pump plug to the printed circuit interrupted board.
- Page 5 Locating Blockage in Lincoln Quicklub Systems Description In a Lincoln Quicklub Lubrication System, free flow of lubricant from the pump through the transmission system and the bearings is necessary. If any portion of this transmission system (a divider valve, line fitting or any bearing) does not freely accept and pass its portion of the lubricant a blockage has occurred.
- Page 6 Cleaning the divider valve will usually result in only temporarily solving the problem. Consult your lubricant supplier for recommendations on alternate lubricants and your local Lincoln Distributor to verify compatibility with centralized lubricating systems...
Need help?
Do you have a question about the Quicklub Series and is the answer not in the manual?
Questions and answers
Как настроить время смазки