Sealey SNA98 Instructions

Sealey Group,
Bury St. Edmunds,
Suffolk.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter
data, specifications and component parts without prior notice.
IMPORTANT: No responsibility is accepted for incorrect use of this equipment
WARRANTY: Guarantee is 12 months from purchase date. Proof of purchase will be required
for any claim.
INFORMATION: Please call us for a copy of our latest catalogue.
01284 757500
01284 703534
E-mail: sales@sealey.co.uk
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE
OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS. USE THIS PRODUCT
CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
FAILURE TO DO SO MAY CAUSE DAMAGE OR PERSONAL INJURY, AND WILL
VALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1.
p WARNING! remove the cutter from the drill before servicing or performing any maintenance.
3 Maintain cutter in good condition (use authorised service agent). Replace/repair damaged
parts. Use recommended parts, alternative parts are dangerous & will invalidate the warranty.
3 Keep cutter clean for best and safest performance and check regularly moving parts.
3 Keep tool bits clean and sharp for best and safest performance. Follow instructions for
lubrication and changing accessories.
3 Remove chuck key from the drill before turning the cutting tool on.
3 Ensure there are no flammable or combustible materials near the work area.
3 Wear approved safety eye protection (standard spectacles are not adequate).
3 Remove ill fitting clothes, ties, watches, rings, and other loose jewellery, and contain long hair.
3 Locate cutter in a clean, tidy working area for its function, and ensure these is good lighting.
3 Maintain correct balance and footing. Ensure the floor is not slippery and wear non slip shoes.
3 Keep children and unauthorised persons away from the working area.
3 Secure non stable work piece with a clamp, vice or other adequate holding device.
3 Start drill before cutting commences, keep drill on until cutter is fully
removed from work piece.
3 Avoid unintentional starting.
7 DO NOT hold the workpiece by hand. Use clamps
or a vice (not included)
7 DO NOT force the cutter to achieve a task it was not
designed to perform.
7 DO NOT allow untrained persons to operate the cutter.
7 DO NOT get cutter wet or use in damp or wet locations
or areas where there is condensation.
7 DO NOT operate the cutter if damaged, or there
are parts missing.
7 DO NOT exceed the rated capacity of the cutter.
7 DO NOT use cutter where there is flammable liquids,
solids or gases.
7 DO NOT leave the cutter operating whilst unattended.
7 DO NOT use cutter if tired, under influence of alcohol, drugs or intoxicating medication.
SNA98 - tu - 110698
3 When not in use switch drill off and remove the cutter and store in a safe, dry, child proof area.
NIBBLER CUTTING TOOL
INSTRUCTIONS FOR:
Model No:
Thank you for purchasing a Sealey product. Manufactured to a high
standard this product will, if used according to these instructions and
properly maintained, give you years of trouble free performance.
SAFETY INSTRUCTIONS
SNA98