Dwin HD-700 Installation And Operating Instructions Manual page 24

Source Memory Copy, Rename or Delete
This will enable you to copy, rename or delete memory occupied by Source Configuration data.
To copy, rename or delete a source memory or to adjust the "Default Memory", press "MENU" to display
the Main Menu and then press "9" to go to the Set Up menu.
Press "5" to select "Copy, Rename or Delete Video Memory". This will display a listing of all Sources
entered into the HD-700's memory. The list of sources is too long to fit on the screen use the
to scroll through the list.
Press number to select active video memory
Memory
0. Default Memory-------------------------------------------------------------------------------
1. Video01
2. Video02
3. Video03
4. Video04
5. Empty05
Press "+10" to Set TranScanner Memories
Press E for previous or F for next memories
Enter the number corresponding to the source you wish to COPY. Press "7" followed by "ENTER" to
"COPY". This will copy the selected source memory data to a new memory position.
Enter the number corresponding to the source you wish to RENAME. Press "8" followed by "ENTER" to
"RENAME". To rename the source, use the
alphanumeric characters. When the first character is set, use the
set the next character using the
next spot and the
designator is on screen, press "ENTER" to save the source name and settings to memory. The system will go
back to the list of inputs, and you will see that your new setting has been added to the list.
Enter the number corresponding to the source you wish to DELETE.
NOTE: Once a source is deleted it is permanently removed from the memory and may not be restored.
If you wish to re-enter the information for a specific source after it has been deleted you will have to
completely re-establish the parameters for that source and save it again.
Press "9" followed by "ENTER" to "DELETE". The system will ask you to press "ENTER" again to confirm
that you wish to delete a source.
Name H. Freq
A 31.5 KHz
TS 4:3 43.5 KHz
TS 1.85
TS 2.35
00.0 KHz
and arrow buttons. Again, when set, use the
and arrow buttons to select the character. When the complete input name or
- 24 -
V.Freq
60 Hz
60 Hz
42.9 KHz 60 Hz
34.4 KHz 60 Hz
00 Hz
Setting Memories for TranScanner
Use D C to set Display Lines: 0525
Then press "1" for 4:3 Screen as in TranScanner
Or "2" for 16:9
and arrow buttons on the remote to cycle through the
button to move to the next position, and
Relay
button to move to the
or buttons