Table of Contents
Advertisement
INSTALLATION 3. SYSTEM SETTINGS
3.2
Parameter Continuous Setting
(1)
Touch [System Management], [System Config.], [Set Parameters], and then
[Set Parameters].
(2)
Select the desired value for each item and touch [ENT].
The underlined value is the default value.
•
Film Size on TRAY 1:
•
Film Size on TRAY 2:
•
Copy F.D.C. Table:
<SUPPLEMENTARY NOTE>
Only [Film Size on TRAY 2] can be set for 20 x 25 cm size film. (However 20 x 25
cm size film displayed at [Film Size on TRAY 1] can not be set.)
(3)
Touch [QUIT].
<NOTE>
If using two film trays, set film tray 1 to a size that is greater than film tray 2,
or set to the same size.(Tray size is not restricted for software version A08,
A09, B00 onwards)
Film tray 1/35 x 43 cm and Film tray 2/26 x 36 cm.......OK
Film tray 1/35 x 43 cm and Film tray 2/35 x 43 cm.......OK
Film tray 1/26 x 36 cm and Film tray 2/35 x 43 cm.......NG
Film tray 1/26 x 36 cm and Film tray 2/26 x 36 cm.......OK
*1: Main unit software version B03 or later.
006-252-05
06.30.01 FM3040
14 x 17" (35 x 43 cm), (26 x 36 cm), 8 x 10" (20 x 25 cm) (*1),
Blue base (*1), Clear base (*1)
14 x 17" (35 x 43 cm), (26 x 36 cm), 8 x 10" (20 x 25 cm) (*1),
Blue base (*1), Clear base (*1)
Enable, Disable (Set "Disable " as standard.)
FM-DP L Service Manual
B3-2
B3-2
Advertisement
Table of Contents
