Holux FunTrek 132 User Manual page 37

The sensor is disconnected, it displays as "---";
The sensor is connected and the signal is good, it displays the data and the icon is blinking;
The sensor is connected, but the signal is poor and the display data shown is below than the minimum
value for 1 to 5 seconds, cadence and speed data decreases, the icon does not blinking;
The heart rate data is displayed as the last time, the icon does not blinking;
The sensor is connected, but the signal is poor or the display data shown is low for 6 seconds to 1 minute,
cadence and speed data are 0, and the icon is not blinking. The signal data is displayed as "???", the alert
beep is on in every 10 seconds;
The sensor is connected and the poor signal lasts more than 1 minute, the cadence, speed and heart rate
are displayed as "---".
FunTrek 132 training information range is: Heart rate 30-220bmp, Cadence 20-255rpm, Speed 2.4-244km/h.
Cadence, speed and heart rate data which are higher than the maximum value, the display will continue to
show the maximum value.
On the training information page, press the
Press the button to switch axis. In the graphics, the dark horizontal bands is the setting rage of heart
rate/cadence. Browse the charts for reference.
Click the heart rate/cadence chart at the top of the "altitude" or "speed" block to enter the information
option lists. Select different information to display on the chart.
In training process, press the "Back" button and a message appears on the screen. Press the
to exit the training, or press the
When training is completed, pops up the training is finished. Press the
saves records. User can view multiple training records in the track management.
"Last training": You can review the detail information of last training. Press the
information.
button to flip to the HR or Cadence graphics page.
button to continue training.
29
HOLUX FunTrek 132
button to ends the training and
button to refresh the
button