Table of Contents
Advertisement
2 Installation
2.1 Installation of Rear Connector Panels
The HDA-3962 card is sized to fit into Grass Valley's Densité 3 frame. Grass Valley Densité-series cards are each
associated with a rear connector panel, which must be installed in the Densité 3 frame before the card can be
inserted.
The following rear connector panels are available for the HDA-3962:
HDA-396N-3SRP
HDA-396N-3SRP-2IN
HDA-396N-3SRP-HF
HDA-3962-3DRP-HR
All cards and rear panels can be installed with the frame power on. The card has connectors which plug into a mid-
frame mother board for distribution of power and for connection to the controller card, and a second connector which
plugs directly into the rear connector panel for input and output.
The rear connector panel must be installed with the card out of the frame.
To remove an existing card from the slot, tilt up the swivel handle on the front of the card to lever the connectors
apart, then use the handle to pull the card straight out of the slot.
To install the connector panel:
1. If a card is installed in the slot whose rear panel is being changed, remove it as described above.
2. Remove the existing panel (either blank or belonging to an existing card that is being changed) by releasing
the captive screw(s) at the bottom.
3. Position the new panel and secure it in place with the captive screw(s) at the bottom.
2.2 Card Installation
Once a matching rear connector panel has been installed, install the HDA-3962 card as follows:
1. Open the front panel of the frame.
2. Slide the HDA-3962 card into the slot and push gently on the handle to seat the connectors.
Single slot rear panel with single 1×7 BNCs.
Single slot rear panel with single 1×6 or dual 2×3 BNCs.
Single slot rear panel with single 1×10 or dual 1×5 HD-BNC with fiber option support.
Double slot rear panel with single 1x10 HD-BNC with Bypass Relays.
Figure 3 Densité 3 frame – rear panel installation
GUIDE TO INSTALLATION AND OPERATION
HDA-3962 | 11
Advertisement
Table of Contents
