Related Manuals for Ferno Stat Trac 185-86
Summary of Contents for Ferno Stat Trac 185-86
- Page 1 Stat Trac® Fastening System Models 185-86, 185-91, 185-96, 185-103 Users’ Manual November 2016 Pub. No. 234-3625-01 Read this Manual and Retain for Future Reference...
-
Page 2: Ferno Customer Relations
Limited Warranty Statement 1.937.382.1451 The products sold by Ferno are covered by a limited warranty, which is printed on all Ferno invoices. The complete terms and conditions of the limited warranty, and the limitations of liability and disclaimers, are also available upon request by calling Ferno at 1.800.733.3766 or... -
Page 3: Table Of Contents
4 - Features _____________________________________________ 10 Maintenance Record __________________________________ 20, 22 Training Record_______________________________________ 21, 23 Mounting Handle _________________________________ 10 Cot Lock, Cot Release Handle ________________________ 10 Safety Stop ______________________________________ 11 Secondary Release ________________________________ 11 © Ferno-Washington, Inc. / 234-3625-01 / November 2016... -
Page 4: Safety Information
Use of a Ferno cot/transport system Ferno parts and Ferno-approved service on the Stat Trac. with a non-Ferno fastening system is misuse of the Ferno product. The user assumes responsibility for the outcome of known, intentional misuse. -
Page 5: Compliance: Global
How to Meet SAE J3027 SPECIFICATIONS AND STANDARDS U.S.A. SAE J3027 Recommended Practice requires all three When properly installed and used with appropriate additional Ferno elements to be present together: products, the fastening system meets or exceeds the following Compliant ambulance cot or transport system specifications and standards listed below. -
Page 6: Responsibility Of User To Maintain A Safe Fastening System
WARNING Safe Fastening System Improper installation can cause injury. The installer The Ferno® Stat Trac® Fastening system is designed to securely hold an should test your fastening system setup to meet or exceed ambulance cot inside a ground-based ambulance. all applicable guidelines. -
Page 7: Operator Focus
(referred to as the Stat Trac in this manual) are devices designed the purpose described in this manual. to secure a Ferno cot or transporter inside a ground-based ambulance. See “Fastening System Compatibility” on page 4. Each Stat Trac is sold with one track and one Installation and Users’... -
Page 8: Compatible Cots/Transporters
About the Stat Trac 3.2 Compatible Cots/Transporters WARNING The Stat Trac is for use with the following Ferno cots that have been An improper cot can cause injury. Use only Ferno cots designed specifically for use with the Stat Trac: designed or properly modified for use with the Stat Trac. -
Page 9: Components
Mounting Handle Safety Stop Funnel Lock Slot Bumper Components Common to All Models (Left, Above) Release Handle The only variation between Stat Trac models is the distance of the components from the funnel © Ferno-Washington, Inc. / 234-3625-01 / November 2016... -
Page 10: Features
(Figure 3) and pull the cot to the right to position the control-end loading post in the center of the channel. For complete unloading instructions, see “Unloading a Cot” on page 13. © Ferno-Washington, Inc. / 234-3625-01 / November 2016... -
Page 11: Safety Stop
(Figure 5). After the cot has been rolled against the safety stop (see “Safety Stop” on page 11), the operator moves the secondary release down to lower the safety stop. © Ferno-Washington, Inc. / 234-3625-01 / November 2016... -
Page 12: Using The Stat Trac
5 - USING THE STAT TRAC 5.1 Compatible Cots WARNING The Stat Trac is for use only with Ferno cots and transporters. See Improper operation can cause injury. Operate the Stat “Fastening System Compatibility” on page 4 and “Compatible Cots/ Trac only as described in this manual. -
Page 13: Unloading A Cot
The operators should roll the cot firmly against the safety stop. This confirms to the operators that the cot is held securely by the safety stop before the undercarriage/legs are raised or lowered. © Ferno-Washington, Inc. / 234-3625-01 / November 2016... -
Page 14: Checking The Stat Trac With The Ambulance Floor
Adjust the fastener-post brackets second. See “Adjusting the Fastener-Post Brackets” on page 16. If the Stat Trac cannot be adjusted to fit the floor plates, see “Troubleshooting” on page 18. Post with Slotted End © Ferno-Washington, Inc. / 234-3625-01 / November 2016... -
Page 15: Adjusting The Fastener Posts
If the Stat Trac shows any of these symptoms, Overtightening may cause difficulty in un- see “Troubleshooting” on page 18. mounting and mounting the Stat Trac to the ambulance floor. © Ferno-Washington, Inc. / 234-3625-01 / November 2016... -
Page 16: Adjusting The Fastener-Post Brackets
See “Mount the Stat Trac to the Ambulance Floor” on page 14. loosen but do not remove the four bracket hex screws. If the Stat Trac cannot be mounted, contact Ferno. See “Ferno Customer Relations” on page 2. Center Brackete: (Models 185-96 and 185-103 only): Use a 7/16”... -
Page 17: Maintenance
Inspecting (this page) Wipe all surfaces with disinfectant. Follow the disinfectant manufacturer’s instructions for application method and contact time. Ferno recommends you inspect the Stat Trac for damage as you disinfect. Important Disinfectants and cleaners containing bleach, phenolics, or 6.3 Cleaning the Stat Trac iodines can cause damage. -
Page 18: Troubleshooting
Troubleshooting 7 - TROUBLESHOOTING 7.1 Troubleshooting Table If the corrective actions listed here do not solve the problem, contact Ferno or your ambulance manufacturer for assistance. See “Ferno Customer Relations” on page 2. Problem Cause Corrective Action 1) Stat Trac is being inserted into the floor 1) Load both ends of the Stat Trac in the plates incorrectly. -
Page 19: Parts And Service, Accessories
056-7061 Beauty Ring Kit 185-96 056-7062 Beauty Ring Kit 185-103 Ferno offers a full line of accessories approved for installing the Stat 056-7057 Deluxe Retrofit Install. Kit 185-86, 185-91 Trac. Always follow the instructions packed with accessories. Keep the 056-7060 Deluxe Retrofit Install. -
Page 20: Maintenance Record
Maintenance Record MAINTENANCE RECORD Date Maintenance Performed © Ferno-Washington, Inc. / 234-3625-01 / November 2016... -
Page 21: Training Record
Training Record TRAINING RECORD Training Method Trainer Date Printed Name Signature Read Video/ Initials Hands-On Manual Online © Ferno-Washington, Inc. / 234-3625-01 / November 2016... - Page 22 Maintenance Record MAINTENANCE RECORD Date Maintenance Performed © Ferno-Washington, Inc. / 234-3625-01 / November 2016...
- Page 23 Training Record TRAINING RECORD Training Method Trainer Date Printed Name Signature Read Video/ Initials Hands-On Manual Online © Ferno-Washington, Inc. / 234-3625-01 / November 2016...
- Page 24 © Ferno-Washington, Inc. / 234-3625-01 / November 2016...
Need help?
Do you have a question about the Stat Trac 185-86 and is the answer not in the manual?
Questions and answers