Advertisement
Mustang Micro can be used as digital recording software output by using a USB cable to con-
nect the USB-C jack (H) on the bottom of the unit to the USB port on the user's Mac or PC.
To perform a Mustang Micro firmware update, follow these three steps:
1. With Mustang Micro off, press and hold the "+" TONE BUTTON (D).
2. With one end of a USB cable connected to a Mac or PC, connect the other end to Mustang
Micro's USB-C jack.
3. Release the "+" TONE BUTTON.
Successful initiation of firmware update mode is then indicated by a solid white POWER SWITCH LED (G) for 10
seconds; the white LED will then begin flashing to indicate an update in process.
When a firmware update is complete, the POWER SWITCH LED will illuminate solid green for 10 seconds and then
extinguish to indicate a successful update; the LED will illuminate solid red for 10 seconds and then extinguish to
indicate a failed update. Mustang Micro is automatically powered up during the firmware update process; when
an update is completed successfully, Mustang Micro must then be restarted.
FIRMWARE UPDATE
INITIATED (SOLID)
IN PROCESS (FLASHING)
A Mustang Micro factory reset can be performed that resets all buttons (AMP, TONE, FX,
FX LEVEL) to their original factory values and clears the Bluetooth paired device list.
Initiate factory reset mode by turning Mustang Micro on while holding the "+" FX BUT-
TON (E) for three seconds.
Do LEDs do anything during factory reset?
RECORDING
FIRMWARE UPDATE
FIRMWARE UPDATE
SUCCESSFUL (SOLID)
FACTORY RESET
8
FIRMWARE UPDATE
FAILED (SOLID)
Advertisement
Need help?
Do you have a question about the Mustang Micro and is the answer not in the manual?
Questions and answers
steps to make it work Mustang Micro
1. Connect to Guitar or Bass: Plug the Mustang Micro directly into your instrument using the 1/4" rotating input plug.
2. Power On: Turn on the Mustang Micro.
3. Select Settings:
- Choose an amp model.
- Select an effect and adjust the effect parameter.
- Set volume and tone controls.
4. Use Bluetooth (Optional): Enable Bluetooth to stream music for play-along practice or online instruction.
5. Monitor or Record:
- Use headphones or earbuds to listen.
- Connect via USB to a Mac, PC, or mobile device for recording.
6. Recording Setup:
- Connect the Mustang Micro to a computer using a USB-C cable.
- No external driver is needed for Apple computers.
- Use digital recording software and set the Mustang Micro as the input device.
7. Firmware Update (if needed):
- Connect the Mustang Micro to a computer via USB.
- Hold the AMP “-” button while turning the unit on.
This setup allows for practice, recording, and Bluetooth streaming.
This answer is automatically generated