Table of Contents
Advertisement
10.4.3
Spare parts
For a list of spare parts, see MTparts, 3 842 529 770.
11 Decommissioning
The product is a component that does not need to be taken out of service.
Therefore, the chapter in these instructions contains no information on the topic.
12 Disassembly and replacement
High electrical voltage!
Risk of serious injury and even death from electrical shock.
Disconnect the relevant system component before you perform maintenance and
repair work.
Secure the system against unintentional restarting.
High pneumatic pressure!
Risk of serious injury and even death.
Disconnect the relevant system component from the pneumatic pressure source
before you perform maintenance and repair work.
Secure the system against unintentional restarting.
Raised loads can fall down!
Serious injury (or death) can occur if the product falls down.
Use only slings with suffi ciently high load capacity (for product weight see
shipping documents).
Check if the carrying straps are attached properly before lifting the product.
The product must always be prevented from tipping over when lifting.
During raising and lowering pay attention that nobody other than the operator is
in the danger zone.
12.1 Preparing the product for storage/re-use
• Only set the product down onto a level surface.
• Protect the product from mechanical infl uences.
• Protect the product from environmental infl uences such as dirt and moisture.
• Pay attention to the ambient conditions, see page 54.
• For products with mounted motor, support the product so that hanging-mounted
engines will not be burdened.
Decommissioning
WARNING
3 842 358 796/2015-01, MIT: HD 2/H, Bosch Rexroth AG
49/56
Advertisement
Table of Contents
