ISO Preferred BA205 Instructions

Lumbar Back Brace V
The ISO Preferred Lumbar Back Brace V reduces the time it takes to heal discomfort from
injuries or post-surgery. Please follow your orthopedic professional's instructions explicitly
and adjust or discontinue use only as directed to achieve maximum benefit for your
concerns.
ISO Preferred Lumbar Back Brace V (BA205) has a heat moldable posterior panel and a rigid front plate. It is intended to provide
support for mild disc herniation of the lumbar, strain or sprain of the lower back, Spondylosis, Spondylolisthesis, Lumbago, Spinal
Stenosis, Facet Syndrome, Burst fracture, and Post-op disc surgery.
1
. The belt is designed to fit waist sizes Small to 2XL. To apply, lay out the back brace on a
flat surface. Ensure the pull tabs are nearest to the middle of the back of the brace without
the cords bunching up.
2. Position the center of the lumbar back brace over your spinal region at your desired
height. Pull firmly and equally on both sides of the support belt, wrapping and overlapping
them in front of your stomach. Then secure together with fastening fabric.

If the belt is too long or too short, turn belt to inside.

Unfasten the belt overlap at position "A".

Adjust the length on each side.
 Adjust both belts equally to position front and back
plates properly. Excess belt may be cut as desired.

Proceed to apply and fasten the belt as instructed above
3. Detach both pull tabs (attached to the cords) from the support belt. While pulling slowly
towards the front of your stomach, firmly and evenly increase the compression support
to your doctor's prescribed specific level. Re-attach both pull tabs.
OVERTIGHTEN.
ISO Lumbar Belt Extension: Universal (Optional- BA202)
For additional length at the waist securely fasten the (optional) ISO Lumbar Belt
Extension: Universal to each side of the ISO Lumbar Belt.
Always Putting Our Patients First
ISO PREFERRED, 1419 DONELSON PIKE, SUITE A, NASHVILLE, TN 37217
ISOPREFERRED.COM
1
A
2
A
3
2
DO NOT
jljlkjljljlk