Sealey MS025 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instructions protection
1. SAFETY
WARNING! Ensure Health and Safety, local authority and general workshop practice regulations are adhered to when using tools.
‰
DO NOT use this tool if any parts are missing or damaged.
8
DO NOT use this tool for any purpose other than that for which it is designed.
8
Wear approved eye protection. A full range of personal safety equipment is available from your Sealey Stockist.
9
Wear suitable clothing to avoid snagging. DO NOT wear jewellery and tie back long hair.
9
Maintain correct balance and footing, DO NOT over-reach. Ensure the floor is not slippery and wear non-slip shoes.
9
Keep children and other unauthorised persons away from the working area.
9
Keep yourself and tools away from hot engine parts.
9
Maintain the tool components in a good and clean condition for best and safest performance.
9
Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
9
Ensure that the motorcycle is standing on a level surface and that it is adequately supported on its own centre stand, or by other means,
9
before commencing any work.
Ensure that the motorcycle's engine is turned off.
9
DO NOT use this tool when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
When work is completed, clean tools and replace in the carrying case and store in a safe, dry, childproof location.
9
2. INTRODUCTION
Comprehensive set designed to shorten and lengthen motorcycle chains by removing or replacing links. Set is also ideal for use on
horticultural and agricultural machinery. Includes tools designed for riveting and plate holder for connecting links accurately. Suitable for most
sizes of final drive chains #520 - #532.
3. CONTENTS
Pin Holder, U-Holder, Plate Holder, Pins - 3, 4, 5mm, Anvils - 3, 4, 5mm
© Jack Sealey Limited
HEAVY-DUTY MOTORCYCLE CHAIN
SPLITTER & RIVETING TOOL SET
MODEL NO:
Wear protective
gloves
Original Language Version
MS025
fig.1
MS025 Issue 2 10/01/20