Download Print this page
Sealey AK2923 Instructions
Sealey AK2923 Instructions

Sealey AK2923 Instructions

Cordless glue gun 3.7v

Advertisement

Quick Links

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
Wear
instruction
protective
manual
gloves
1. SAFETY
1.1.
GENERAL SAFETY
Familiarise yourself with this products application and limitations, as well as the specific potential hazards peculiar to the glue gun.
9
WARNING! Disconnect the charging lead before changing accessories, servicing or performing any maintenance.
Maintain the glue gun in good condition (use an authorised service agent).
9
Replace or repair damaged parts. Use recommended parts only. Unauthorised parts may be dangerous and will invalidate the
9
warranty.
WARNING! Always wear approved eye or face protection when operating the glue gun.
Keep the work area clean, uncluttered and ensure there is adequate lighting.
9
Remove ill fitting clothing. Remove ties, watches, rings, and other loose jewellery, and contain and/ or tie back long hair.
9
Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes,
9
Secure non stable workpiece with a clamp, vice or other adequate holding device.
9
DO NOT touch the hot nozzle or the silicon cap.
8
DO NOT use the glue gun for a task it was not designed to perform.
8
DO NOT operate the glue gun if any parts are damaged or missing as this may cause failure and/or possible personal injury.
8
DO NOT hold the workpiece by hand. Use clamps or a vice (not included) to secure the workpiece. Available from your Sealey stockist.
8
DO NOT get the glue gun wet or use in damp or wet locations or areas where there is condensation.
8
DO NOT place nozzle close to your face (especially eyes, ears, etc) or other persons or animals.
8
DO NOT allow children or untrained persons to operate the glue gun.
8
DO NOT operate the glue gun when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOT get glue on your skin.
8
DO NOT inhale any vapour given off by the glue.
8
DO NOT carry the glue gun with your finger on the power switch, or carry by the charging cable.
8
DO NOT use the glue gun where there are flammable liquids, solids or gases such as paint solvents, etc.
8
DO NOT leave the glue gun operating/heating up unattended.
8
Protect work surface from glue spilt during warm up phase and whilst being used.
9
After use place the glue gun down to cool in a safe manner. Ensure it has cooled down completely before storage.
9
When not in use switch the glue gun off, remove plug from the power supply, store the tool in a safe, dry child proof area.
9
NOTE: This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or
lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the
appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
1.2.
ELECTRICAL SAFETY
Inspect the cable and connector for wear and damage to ensure items are safe before connecting to the power supply. If worn or
9
damaged DO NOT use.
Ensure the glue gun is fully charged before initial use.
9
DO NOT charge in damp conditions.
8
DO NOT use the glue gun if you suspect that the battery or the lamp casing is damaged.
8
DO NOT leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery, subsequently
8
recharge the battery at least once every six months of non-use.
DO NOT attempt to open, disassemble, modify or service the battery pack.
8
DO NOT crush, puncture, short external contacts or dispose of in fire or water.
8
DO NOT expose to temperatures above 60°C (140°F).
8
Replace only with the battery pack designated for this product.
9
Recycle or dispose of used battery as stipulated by local regulation.
9
If the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. If it gets in your eyes, rinse thoroughly with cool
9
water and seek immediate medical attention.
© Jack Sealey Limited
CORDLESS GLUE GUN 3.7V
AK2923
MODEL NO:
Warning!
hot
surface
Original Language Version
AK2923 | Issue:1 28/05/19

Advertisement

loading

Summary of Contents for Sealey AK2923

  • Page 1 AK2923 MODEL NO: Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
  • Page 2 2. INTRODUCTION Lightweight cordless glue gun powered by a 3.7V 1.3Ah Lithium-ion battery. Features LED light indicators to show when fully heated up. Ready to use in 20 seconds. Operating time of 30 minutes on a full charge. Supplied with four glue sticks and a USB charging cable. Suitable for Ø7.2mm glue sticks. 3. SPECIFICATION Model no ..............AK2923 Charging time ............3-4 hours Operating time ............30 minutes Battery power ..............1.3Ah 4. BATTERY CHARGING 4.1. Only use the supplied charging cable. 4.2. The battery is supplied partially charged. Charge the battery for at least 2-3 hours before first use. 4.3. The glue gun can not be used during charging. 4.4. The battery can be charged at any time without reducing its service life. Interupting the charging procedure does not damage the battery. 4.5. The battery is protected from deep discharging. When the battery is dischaged the glue gun is switched off by a protective circuit. The glue is no longer heated. 4.6. BATTERY LED INDICATOR (RH)
  • Page 3 Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid waste authority for recycling information. ENVIRONMENT PROTECTION Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids according to local regulations. Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice. Important: No Liability is accepted for incorrect use of this product. Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim. Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR 01284 757500 01284 703534 sales@sealey.co.uk www.sealey.co.uk Original Language Version © Jack Sealey Limited AK2923 | Issue:1 28/05/19...