Summary Of Lights; How To Use The Micropulsing Function - Sota Silver Pulser SP7 Manual

The Silver Pulser Model SP7 Manual

SUMMARY OF LIGHTS

GREEN: Indicates the unit is on.
RED: Indicates the battery is low and will soon need replacing.
YELLOW: Indicates the Micropulsing function is in operation.
ORANGE: Indicates the Ionic~Colloidal Silver function is in operation.

HOW TO USE THE MICROPULSING FUNCTION

1. Place the 9-Volt Alkaline battery in the unit.
a. On the back of the unit, slide off the
battery cover.
b. Position the 9-Volt Alkaline battery so
the positive (+) and negative (-) terminals
line up as in image 1 or image 2. Your
unit will either have a small circle & large
circle embedded in the plastic case as in
image 1 OR the label inside the case will
be shaped like a battery and show you
the terminals as in image 2.
c. Slide the 9-Volt Alkaline battery into the
case and push down. Slide the cover back
onto the unit.
2. Attach the Conductive Rubber Probes to the
Micropulsing Cord by gently sliding the
Rubber Probes over the metal pins on the
Micropulsing Cord, as in image 3.
3
© 2014-2021 SOTA Instruments Inc.
Note: Except to occasionally clean them, the
Rubber Probes can stay on the Micropulsing
Cord between uses.
3. Clean the wrist area to remove oils from the
skin. This will allow for better conductivity.
4. Slide the Arm Band up the arm to a
comfortable position. Tighten the band to secure
it in place as in image 4.
1
2
Page 6 of 16| www.sota.com