Dell 4100 Service Manual page 73

Table A-4. Advanced Menu Categories
Category
Serial Port 1 or
Serial Port 2
Parallel Port
Parallel Mode
Diskette Controller
On-Board SCSI A
On-Board SCSI B
PCI Scan Sequence
Use MP Specification
PS/2 Mouse
Function
Configures system's built-in serial ports.
Configures system's built-in parallel port.
The port's I/O address may be set to:
278H, IRQ5; 3BCH, IRQ7; 378H, IRQ7
Otherwise, the port may be disabled.
Controls whether system's built-in parallel
port acts as an AT-compatible (Output
Only), PS/2-compatible (Bidirectional), or
ECP (extended capabilities port).
Enables system's built-in diskette
controller.
Enables or disables the built-in SCSI 7880
Ultra/Wide controller and determines if it is
scanned as a boot drive.
Enables or disables the built-in SCSI 7860
Ultra/Narrow controller and determines if
it is scanned as a boot drive.
Determines the sequence the PCI devices
are scanned to find a boot device (default is
Embedded devices first).
Determines the microprocessor-
specification revision level: either 1.1 or
1.4 (default).
Enables or disables the built-in mouse con-
troller.
.
System Setup Program A-7