Adding Memory - Dell 2100 User Manual

9. If you relocated or permanently removed an
EISA expansion card, enter the change into the
EISA Configuration Utility.
See Chapter 5, "Using the EISA Configuration Util-
ity," for instructions.
NOTE: If you removed a PCI expansion card, your
system automatically performs any required recon-
figuration tasks during the boot routine.
A
dding Memory
The four DIMM sockets (shown in Figure 7-5) on the
system board can accommodate 16 to 512 megabytes
(MB) of dynamic random-access memory (DRAM). The
PowerEdge 2100 systems use 72-bit, buffered, extended data
output (EDO) DIMMs in these 168-pin sockets. Error check-
ing and correction (ECC) is performed by the memory
controller in the system board chip set. Figure 7-1 shows the
location of the DIMM sockets on the system board.
Figure 7-5. DIMMs and DIMM Sockets
DIMM_D
DIMM_C
DIMM_B
DIMM_A
Installing System Board Options 7-89