Sealey PS9821 Instructions

thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to
instruction
manual
1. safety
ˆ
Warning! ensure all Health and safety, local authority, and general workshop practice regulations are strictly adhered to when
using tools.
8
do not use tools if damaged or worn.
9
maintain the tools in good and clean condition for best and safest performance.
9
ensure all threads are clean and well lubricated.
9
Always check that puller is correctly assembled and is square with the workpiece.
9
if vehicle is raised, ensure it is adequately supported with axle stands, ramps, etc. as appropriate.
9
Wear suitable clothing to avoid snagging. do not wear jewellery. tie back long hair.
9
Wear approved eye protection. A full range of personal safety equipment is available from your sealey stockist.
9
Where possible shield workpiece with canvas or similar to provide protection against failed parts.
8
do not heat puller jaws when heating a gear or bearing as this will affect the temper and, therefore, the strength of the material.
8
do not use any tool or lever to turn the ram tommy bar, use hand effort only.
8
do not hit workpiece, or ram, with a hammer if workpiece has not moved with maximum puller force applied. use a larger capacity puller.
8
Account for all tools and parts being used and do not leave them in or on the vehicle.
▲
iMportant: Always refer to the vehicle manufacturer's service instructions, or proprietary manual, to establish the correct procedure
and data. these instructions for use are provided as a guide only.
2. introduction
forged steel 3 way bearing separator and gear puller set. operated with supplied 10tonne hydraulic ram or manual force screw. features a
selection of extension rods depending on reach required.
3. specification
Model no: ................................................................. ps9821
Puller leg reach: ......................................................... 160mm
Puller leg size/spread: ................................................ 190mm
separator capacity: ................................................. 30-84mm
extension rods (x4): ............................... 15, 65, 185, 340mm
manual thrust screw length: .................................... 210mm
4. contents
part no. description
Ps9821.01 Hydraulic ram 10tonne
Ps9821.02 triple beam
Ps9821.03 Bearing separator 30-84mm
Ps9821.04 Puller leg (set of 3)
Ps9821.05 force screw 210mm
Ps9821.06 central nut
Ps9821.07 extension rod 15mm (set of 3)
Ps9821.08 extension rod 65mm
Ps9821.09 extension rod 185mm
Ps9821.10 extension rod 340mm
Ps9821.11 ram repair kit
sn10.s m10 nut
fWm10.s m10 washer
Ps9821.Bmc Blow mould case
© Jack sealey limited
instructions for
hydraulic bearing separator/puller
ps9821
model no:
Wear eye
protection
c
Original Language Version Ps9821 issue:3 (H,4,f) - 14/03/18