Mulch Plate - Lawn-Boy Euro Series Operator's Manual

Accessories
2. Reassemble hanger clamps to handle sections
using whichever set of holes best holds bag taut.
Using lower holes in hanger clamps tightens bag
assembly and upper holes in hanger clamps
loosens bag assembly.
Note: Under normal use, bag materials are
subject to deterioration and wear.
Check grass bag often and replace
when necessary with an original
equipment replacement bag. A
weakened or inferior bag may let
objects pass through, causing injury.
POTENTIAL HAZARD
Keep hands, sticks or other objects out of
grass chute while blade is turning.
WHAT CAN HAPPEN
Thrown objects or blade contact can cause
serious injury.
HOW TO AVOID THE HAZARD
Always stop engine when emptying grass
bag and disconnect spark plug wire before
cleaning a clogged chute, bag tunnel or
underside of mower housing.
3. Reconnect spark plug wire.
GB–26

Mulch Plate

POTENTIAL HAZARD
An uncovered discharge opening will allow
objects to be thrown in operator's or
bystander's direction. Also, contact with
blade could occur.
WHAT CAN HAPPEN
Thrown objects or blade contact can cause
serious injury.
HOW TO AVOID THE HAZARD
Never operate mower unless cover plate,
mulch plate or grass chute and catcher are
installed.
1. Stop engine and disconnect spark plug wire
(Fig. 32) before installing or removing mulch
plate.
2. Place front corner of mulch plate baffle into deck
opening. Rotate mulch plate counterclockwise
and push down into deck opening (Fig. 42).
IMPORTANT: Mulch plate baffle must go
behind front deck baffle and between blade
and toe guard to prevent contact with blade.
Figure 42
1. Chute baffle
2. Deck baffle
1
3
2
3. Toe guard
1073