Lan Settings; Change The Lan Ip Address - TP-Link TL-MR100 User Manual

Chapter 10
3 Enable Data Limit
data overuse.
4 Enter the allowed amount of total/monthly data in the
When data usage exceeds the allowed level, the router will disconnect from the
internet and notify you on the
5 Enter a percentage in the
usage reaches the alert level, a warning will be shown on the
Page. If you want to want receive the alert on your phone, enter your mobile phone
number in the SMS Alert for Usage
6 Enable Monthly Data Statistics
starts.
7 Enter the start date of the billing cycle in the
8 Click Save to save the settings.
10 4

LAN Settings

10 4 1

Change the LAN IP Address

The router is preset with a default LAN IP 192.168.1.1, which you can use to log in to
its web management page. The LAN IP address together with the Subnet Mask also
defines the subnet that the connected devices are on. If the IP address conflicts with
another device on your local network or your network requires a specific IP subnet, you
can change it.
Follow the steps below to change your IP address.
1 Visit http://tplinkmodem.net, and log in with the password you set for the router.
2 Go to Advanced
3 Type in a new IP Address
4 Select the Subnet Mask
the IP address identifies the local IP subnet.
to set total/monthly data allowance and usage alert to prevent
Basic >
Usage Alert
field.
to reset data statistics when the next billing cycle
> Network > LAN Settings
as needed.
from the drop-down list. The subnet mask together with
Specify Your Network Settings
Total/Monthly Allowance
Network Map Page.
field to prevent data overuse. When data
Start Date field.
page.
field.
Basic > Network Map
44