ORDER NO. MD0703025CE Speaker System SB-WAK750PL Colour (K)...Black Type Specifications Type 1 way, 1 speaker system (Bass reflex) Mass 4.4 kg Speaker(s) Subwoofer 16 cm cone type Notes: 6 Ω Impedance 1. Specifications are subject to change without notice. Mass and dimensions are approximate.
SB-WAK750PL 1 System Combination 1.1. System Breakdown Note: The table below show the breakdown for speaker combinations used in main unit system. System SC-AK750PL-K Music Center SA-AK750PL-K Front Speakers SB-AK750PL-K Subwoofer SB-WAK750PL-K System SC-AK750GCP-K Music Center SA-AK750GCP-K Front Speakers SB-AK750PL-K...
SB-WAK750PL 2 Assembling and Disassembling 2.1. Caution “Attention Servicer” Some chassis components may have sharp edges. Be careful when disassembly and servicing. 1. This section describes procedure for checking the operation of replacing the main components. 2. For reassembly after operation checks or replacement, reverse the respective procedures.
SB-WAK750PL 2.4. Disassembly of Rear cabinet assembly Step 3: Detach the front panel as arrow shown. Step 1: Remove 4 screws from front panel. Step 4: Detach the (+) red and (-) black wires from woofer. Step 2: Insert flathead screwdriver into the grooves to push the front panel as arrow shown.
SB-WAK750PL 3 Connection of the Speaker Cables · Be sure to connect speaker cables before connecting the Connection AC power supply cord. · The load impedance of any speaker used with this unit must be 6 Ω. · Be sure to connect the cable from the right speaker to the right terminal and the cable from the left speaker to the left terminal.
SB-WAK750PL 5 Replacement Parts List Notes: · Important safety notice: When replacing any of these components, be sure to use only manufacturer’s specified parts shown in the parts list. · [M] markings in the Remarks columns indicates parts supplied by PAVCSG.