4.
Assemble needle valve (E) with lever arm (F), shaft
(G) and spring (H), and tighten screw (D).
See figure 40.
5.
Check using a ruler or the like that the lever is in le-
vel with the assembly plane on the cover. If neces-
sary, the lever arm can be bent, see figure 41.
7.
Fit gasket (C), the control diaphragm (B) and the
pump cover (A). See figure 42.
8.
Carry out a pressure test. See "Pressure testing
the carburettor".
G
E
Fig 40
Fig 41
Fig 42
Repair Instructions
D
F
H
A
B
C
41
English -