HiB Vapor 50 Manual

Vapor 50, 60 & 80 Cabinet
Vapor 50
Thank you for purchasing this HiB product.
Please read through these instructions carefully and refer back to them during installation to ensure that
your product is fitted safely and that it retains its high quality finish.
Please retain this leaflet for future reference.
Before drilling, ensure there are no hidden cables or pipes in the wall. Ensure the domestic electrical
mains supply to which the product is being connected is turned off for installation.
Please Note This cabinets is controlled by a PIR sensor with a minimum activation distance of
600mm between the sensor and any solid object/surface with a delayed response time of approximently two
seconds. The cabinet will remain on until the PIR sensor is not obstructed for approximately 5 Minutes.
1)These products must be installed with a minimum distance of 300 mm between the infrared sensor switch and
any surface or object to ensure correct operation of the sensor.
The front edge of the basin should be less than 600 mm when measured from the front of the cabinet.
2)The cabinet is a Class 1 appliance and, as such, must be connected to the earth wire of the household power
supply.
3) USB Socket
If an appliance is connected and the current draw exceeds 1.5A, the USB driver will automatically go into
protective shutdown mode and the LED light on the USB socket will ash.
Disconnecting the appliance will reset the USB driver.
Any appliance that requires more than 1.5A current should not be used in the USB socket.
51400
Vapor 60 & 80
Art No.
51500 & 51600
FI #02 018 R171116 Ver No.
approximately
1.0 Jan 2018