Assigning An Ip Address Using Http - AudioCodes MediaPack MP-114 Quick Installation Manual

3.2.3

Assigning an IP Address using HTTP

You can assign an IP address to the gateway using the gateway's Embedded Web Server (based
on HTTP), by connecting the gateway to a PC with a direct, local Ethernet connection.
To assign an IP address to the gateway using HTTP, take these 5 steps:
Connect your PC to the gateway by performing the following:
1.
Disconnect the gateway from the network and reconnect it to your PC using one of the
a.
following methods:
♦
♦
Change your PC's IP address and subnet mask to correspond with the gateway's
b.
factory default IP address and subnet mask (listed in
Access the gateway's Embedded Web Server (refer to Section
2.
Setup' screen is displayed (Quick Setup menu), as shown in the figure below:
Quick Installation Guide
Use a standard Ethernet cable to connect the network interface on your PC to a
port on a network hub or switch. Use a second standard Ethernet cable to connect
the gateway to another port on the same network hub or switch.
Use an Ethernet cross-over cable to directly connect the network interface on your
PC to the gateway.
Figure 3-6: Quick Setup Screen
MP-11x & Microsoft Office Communications Server 2007
Table
16
3-1).
3.1.1 on page 10); the 'Quick
3
3
3
Document #: LTRT-26301