Sealey RD800 Manual

thank you for purchasing a Sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
Hot surfaces
instructions
1. Safety
1.1. eleCtriCal Safety
warninG! It is the user's responsibility to check the following:
‰
Check all electrical equipment and appliances to ensure that they are safe before using. Inspect power supply leads, plugs and
all electrical connections for wear and damage. Sealey recommend that an RCd (Residual Current device) is used with all electrical
products. You may obtain an RCd by contacting your local Sealey stockist.
If the product is used in the course of business duties, it must be maintained in a safe condition and routinely PAT (Portable
Appliance Test) tested.
electrical safety information, it is important that the following information is read and understood.
ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply.
9
Regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that they are secure.
9
important: Ensure that the voltage rating on the appliance suits the power supply to be used and that the plug is fitted with the
correct fuse - see fuse rating in these instructions.
do not pull or carry the appliance by the power cable.
8
do not pull the plug from the socket by the cable.
8
do not use worn or damaged cables, plugs or connectors. ensure that any faulty item is
8
repaired or is replaced immediately by a qualified electrician.
This product is fitted with a BS1363/A 13 Amp 3 pin plug.
If the cable or plug is damaged during use, switch off the electricity supply and remove from use.
Ensure that repairs are carried out by a qualified electrician.
Replace a damaged plug with a BS1363/A 13 Amp 3 pin plug. If in doubt contact
a qualified electrician.
a) Connect the GREEN/YELLOW earth wire to the earth terminal 'E'.
b) Connect the BROWN live wire to the live terminal 'L'.
c) Connect the BLUE neutral wire to the neutral terminal 'N'.
ensure that the cable outer sheath extends inside the cable restraint and that the restraint is tight.
Sealey recommend that repairs are carried out by a qualified electrician.
9
If an extension reel is used it should be fully unwound before connection. A reel with an RCd fitted
is preferred since any appliance plugged into it will be protected. The cable core section is important and should be at least 1.5mm²,
but to be absolutely sure that the capacity of the reel is suitable for this product and for others which may be used in the other
output sockets, we recommend the use of 2.5mm² section cable.
1.2. General Safety
warninG! disconnect the heater from the mains power, before servicing or performing any maintenance, which must only be carried
‰
out by an authorised service agent. Report any oil leakage immediately to an authorised service agent.
Replace or repair damaged parts. Use recommended parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
9
ensure that the heater is used in an area larger than 4m³. Allow a few centimetres of clearance from any surface, and ensure there is
9
good overhead clearance for heat circulation.
only use the heater in an upright position.
9
warninG! do not tamper with the wiring, heating element or oil. The system is a sealed unit. The breaking of any seal may be
‰
dangerous, will damage the heater and will invalidate the warranty.
do not use the heater for anything other than its intended purpose. It is designed for providing heat in enclosed areas, no
8
smaller than 4m³, such as offices, homes, workshops etc. It is not suitable for drying clothes or laundry.
do not place the heater close to a bath, wash basin, shower, swimming pool or any other water-filled area or wet surface.
8
do not get the heater wet or use in areas of high condensation.
8
do not place the heater up against any surface such as a wall, door, furniture etc.
8
do not place the heater immediately below any electrical outlet.
8
do not move the heater whilst it is on, always disconnect from the supply and allow to cool first.
8
do not allow the power lead to touch the radiator surface.
8
do not cover the radiator or use it to dry laundry.
8
do not store the electrical lead until the radiator is cold.
8
do not attempt to repair a damaged heater, contact an authorised service agent.
8
do not stand on the heater.
8
do not touch the heating elements when the heater is on as it becomes very hot.
8
© Jack Sealey limited
oil filled radiator mini 800w/230v
6 element
rd800
model no:
do not cover
Original Language Version
Recommended fuse rating
13 Amp
RD800 | Issue 3 (1) 06/11/18