Set Up The Router As An Access Point - TP-Link Archer AX3000 User Manual

Chapter 4
• If you use Dynamic IP and
please go to Advanced >
• If you still cannot access the internet, refer to the
4. 4.

Set Up the Router as an Access Point

The router can work as an access point, transforming your existing wired network to a
wireless one.
1. Visit http://tplinkwifi.net, and log in with your TP-Link ID or the password you set for
the router.
2. Go to Advanced >
will reboot and switch to Access Point mode.
3. After rebooting, connect the router to your existing wired router via an Ethernet cable.
4. Log in again to the web management page http://tplinkwifi.net, and click
5. Configure your wireless settings and click Next.
PPPoE and you are provided with any other parameters that are not required on the page,
Network > Internet to complete the configuration.
FAQ
Operation Mode, select
section for further instructions.
Access Point and click Save. The router
Set Up Internet Connection
Quick Setup.
19