7.
To remove the display/camera cable, disconnect the cable from the board at the bottom of the display
(1) and the camera at the top of the display (2), and then remove the cable from the clips built into the
side of the display enclosure (3).
8.
If replacing the display enclosure, be sure that the subcomponents (including the camera/microphone
module, the antenna receivers, and all associated cables and hardware) are transferred to the new
enclosure.
Use the following image to determine proper display cable (1) and antenna cable (2) routing.
Reverse this procedure to reassemble and install the display assembly.
Component replacement procedures
55