Table of Contents
Advertisement
FCC Part 15 C Notice
CAUTION:Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
NOTE:This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against
harmful interference in a residential installation.This equipment generates,uses and can radiate radio
frequency energy and,if not installed and used in accordance with the instructions,may cause harmful
interference to radio communications.However,there is no guarantee that interference will not occur in a
particular installation.If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on,the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions :
(1) This device may not cause harmful interference,and
(2) this device must accept any interference received,including interference that may cause
undesired operation.
INDUSTRY CANADA NOTICE: CANADA ONLY.
This device complies with Industry Canada licence-exempt RSS standard(s).Operation is subject to the following two conditions:(1) this
device may not cause interference,and (2) this device must accept any interference,including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.L'exploitation est
autorisée aux deux conditions suivantes :(1) l'appareil ne doit pas produire de brouillage,et (2) l'utilisateur de l'appareil doit accepter
dout brouillage radioélectrique subi,même si le brouillage est susceptible d'en compromettre le fonctionnement.
WARNING!
AVERTISSEMENT:
¡ADVERTENCIA!
CHOKING HAZARD- Small parts.
Not suitable for children under 3 years.
Requires Speed Class 6 or higher microSD or
CHOKING HAZARD - Pièces de petite. taille N'est
pas conçu pour des enfants de moins de 3 ans.
microSDHC card (not included)
PELIGRO DE ASFIXIA- Partes pequeñas. No apto
microSDHC Logo is a trademark of SD-3C, LLC.
para niños menores de 3 años.
Conforms to safety requirements of FCC.
©2016 Rooftop Brands™ All rights reserved
Tel:+ (1) 949-566-9573 • www.propelrc.com
15
Hybrid Stunt Drone with HD camera and
WARNING: Never leave product charging unattended for extended periods of
time. Always disconnect the battery from charger immediately after the battery
Made in China
TILT
™
CAN ICES-3(B)/NMB-3(B)
V1.0
Colors and styles may slightly vary.
TILT
™
Altitude Stabilization Technology
INSTRUCTION BOOKLET
is fully charged. Please refer to enclosed safety instructions.
PACKAGE CONTAINS:
2.4G Wireless
Spare Parts
AC Charger
Controller
& Li-Poly
Rechargeable Battery
ON BOARD
ON BOARD
HD CAMERA
HD VIDEO
1280 x 720 pixel
30 frames per second
USB Card Reader
Instruction
Manual
PROPEL
Advertisement
Table of Contents
Related Manuals for Propel RC TILT
Summary of Contents for Propel RC TILT
- Page 1 TILT ™ FCC Part 15 C Notice CAUTION:Changes or modifications not expressly approved by the party responsible for compliance could Hybrid Stunt Drone with HD camera and void the user’s authority to operate the equipment. Altitude Stabilization Technology NOTE:This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against...
-
Page 2: Table Of Contents
Tilt™ Diagram ........ -
Page 3: Tilt™ Diagram
• Make sure to start your drone on a clean flat level surface before take-off. • IMPORTANT! Until you have experience in flying your TILT ™, it is not advised to use in any rate of wind. Wait until a zero wind day or extremely light wind when learning how to fly. -
Page 4: Now You Are Ready To Fly
Below is a list of basic flight functions for your long-range remote to control the TILT ™.While learning to fly your TILT ™ it is best to start in a large space with the drone facing away from you until you get used to the basic controls.As you master flying your TILT ™... -
Page 5: Channel Flight Control
NOTE:The TILT ™ is already properly trimmed and calibrated right out of the box and should not require any fly your TILT ™ it is best to start in a large space with the drone facing away from you until you get used to trim adjustments before flying.Some more experienced pilots may want to adjust trim settings for their... -
Page 6: Calibrating The Tilt
You have 4 choices a) Forward roll, b) Backwards roll, c) Right side roll, d) Left side roll. 2.Make sure the TILT ™ is on and that the controller is synced (refer to syncing pg 4.).Do not start the blades.Instead move both the throttle and control stick down and to the right corner and hold them there for 5 seconds(See Diagram R).You will see the lights on the drone rapidly flash and stop.Once the... -
Page 7: Using Your On-Board Camera And Video Recorder
Start by making sure that you TILT ™ is properly synced to the controller (see How to Sync pg 4).Note:there and friends. -
Page 8: Troubleshooting Your Tilt
TROUBLESHOOTING YOUR TILT™ TILT™ WARNING: The Tilt™ is designed for OUTDOOR use.The Tilt™’ s blades revolve at high speeds and can cause damage to the user,spectators and animals.Stand away from the Tilt™ to reduce the risk of getting into the flight...
Need help?
Do you have a question about the TILT and is the answer not in the manual?
Questions and answers