JVC KD-SHX705 Service Manual page 13

3.2.2 Removing the top cover
(See Fig.2)
(1) From the back side of the CD mechanism assembly, re-
move the two screws B attaching the top cover.
(2) Take out the top cover upward.
Reference:
When reassembling the top cover, set parts c of the top cover
under the bending parts d of the chassis base.
3.2.3 Removing the mechanism section
(See Figs.2 to 4)
• Prior to performing the following procedure, remove the top
cover.
(1) From the front side of the CD mechanism assembly, re-
move the two screws C attaching the right and left stop-
pers. (See Fig.2)
(2) Remove the two floating springs on the bottom of the body.
(See Fig.3)
(3) Take out the mechanism section upward, and remove the
three damper springs from the dampers. (See Fig.4)
Caution:
• When reassembling the mechanism section, reattach the
damper spring to the damper respectively and insert the
three shafts on the bottom of the mechanism to the damp-
ers. (See Fig.4)
• Before inserting the shaft to the dampers, apply IPA to the
hole of damper.
Top cover
Stopper
C
C
Stopper
Floating spring
Damper
spring(F)
(Silver)
Damper
(Black)
Damper
spring(F)
(Silver)
Damper
(Black)
B
Parts d
Chassis base
Parts c
Fig.2
Fig.3
Mechanism section
Damper
spring(R)
(Red)
Damper
(Purple)
Chassis base
Fig.4
(No.MA048)1-13
B