Canon EOS REBEL T7i Instruction Manual page 415

Transmission status icon
H
(Gray) Not connected : No connection with access point.
H
(Blinking) Connecting...: Connecting to access point.
H
(Illuminated) Connected: Connection to access point established.
H
() Transferring...
Cautions for Using Eye-Fi Cards
Under [Wi-Fi settings] of [51: Wireless communication settings], if

[Wi-Fi] is set to [Enable], image transfer with an Eye-Fi card will not be
possible.
If "J" is displayed, an error occurred while retrieving the card information.

Turn the camera's power switch off and on again.
Even if [Eye-Fi trans.] is set to [Disable], it may still transmit a signal. In

hospitals, on airplanes, and in other places where wireless transmissions are
prohibited, remove the Eye-Fi card from the camera beforehand.
If the image transfer does not function, check the Eye-Fi card and computer

settings. For details, refer to the card's instruction manual.
Depending on the wireless LAN's connection conditions, the image transfer

may take longer or it may be interrupted.
Because of the communication function, the Eye-Fi card may become hot.

The camera's battery power will be consumed faster.

During the image transfer, auto power off will not take effect.

If you insert a wireless LAN card other than an Eye-Fi card, [Eye-Fi settings]

will not appear. Also, the transmission status icon <H> will not appear.
Check the [Access point SSID:].
5
Check that an access point is

displayed for [Access point SSID:].
You can also check the Eye-Fi card's

MAC address and firmware version.
Press the <M> button to exit the

menu.
Take the picture.
6

The picture is transferred and the
<H> icon switches from gray (not
connected) to one of the icons in the
sequence below.
For transferred images, O is

displayed in the shooting information
(p.373).
: Image transfer to access point in progress.
H Using Eye-Fi Cards
415