Before You Start; Install The Charging Base; Charge Your Robovac - EUFY RoboVac 11c Owner's Manual

Before You Start

1. Remove the protective film covering RoboVac and the Charging Base.
2. Flip RoboVac over and snap on the side brushes.

Install the Charging Base

1. Place the Charging Base on a hard, level surface and against a wall.
08
2. Remove objects within 3 ft/1 m of the left and right side and within 6 ft/2 m of the front
of the charging base.
3. Connect the round connector of the adapter into the power socket on the Charging Base
and the other end into a wall outlet.

Charge Your RoboVac

• RoboVac has a pre-installed rechargeable battery that has to be fully charged before use.
• Robovac returns to the Charging Base at the end of a cleaning cycle or when its battery is
running low.
• Manually charge RoboVac when its battery is fully discharged or if it fails to reach the
Charging Base.
Method 1: Attach RoboVac to the Charging Base by aligning its charging pins with the
charging pins on the base.
- Install the Charging Base in a
T
location that RoboVac can easily
access.
- Always keep the Charging Base
plugged in, otherwise RoboVac
will not automatically return to it.
09