Zanussi ZRB35424WA User Manual page 7

WHAT TO DO IF...
Problem
The appliance is noisy.
The lamp does not work.
The lamp does not work.
The compressor operates
continually.
The compressor does not
start immediately after press-
ing the QuickFreeze, or after
changing the temperature.
Water flows inside the refrig-
erator.
Water flows on the floor.
Temperature cannot be set.
The temperature in the appli-
ance is too low/too high.
Possible cause
The appliance is not suppor-
ted properly.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incorrect-
ly.
Many food products were put
in at the same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The QuickFreeze function is
switched on.
This is normal, no error has
occurred.
The water outlet is clogged.
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
The QuickFreeze or Quick-
Chill function is switched on.
The temperature regulator is
not set correctly.
The food products' tempera-
ture is too high.
Many food products are stor-
ed at the same time.
Solution
Check if the appliance stands
stable.
Close and open the door.
Contact the nearest Authorised
Service Centre.
Refer to "Operation" chapter.
Wait some hours and then check
the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before storing.
Refer to "QuickFreeze function".
The compressor starts after a pe-
riod of time.
Clean the water outlet.
Make sure that food products do
not touch the rear plate.
Attach the melting water outlet to
the evaporative tray.
Switch off QuickFreeze or
QuickChill manually, or wait until
the function resets automatically
to set the temperature. Refer to
"QuickFreeze or QuickChill func-
tion".
Set a higher/lower temperature.
Let the food products tempera-
ture decrease to room tempera-
ture before storage.
Store less food products at the
same time.
7