Canon EOS REBEL T7I Wi-Fi (Wireless Communication) Function Instruction Manual page 75

If necessary, also read "NFC Function Cautions" (p.49).

While saving images, a picture cannot be taken even if the camera's

shutter button is pressed.
Do not drop the camera on Connect Station or touch the camera to it with

too much force. Doing so may damage Connect Station's internal hard
disk.
If the camera is not recognized right away, try holding it close to Connect

Station and slowly moving it or rotating it horizontally.
Just holding the camera close to Connect Station may not establish a

connection. In such a case, gently touch Connect Station with the
camera.
When holding the camera close to Connect Station, do not leave

anything between the camera and Connect Station. In addition, when a
case is attached to the camera, a Wi-Fi connection may not be
established with the NFC function.
If the camera and Connect Station are moved too far away from each

other while saving images, saving may take time or the Wi-Fi connection
may be terminated.
If the camera's battery runs out while saving images, saving will stop.

Charge the battery, then try again.
When all images are already saved, saving will not be performed. In

such a case, select [OK] to terminate the Wi-Fi connection.
When there are a large number of images on the memory card, it may

take time to check and save the images.
While saving images, the camera's auto power off does not function.

Saving Images
75