Yamaha 2006 Virago XV250V Owner's Manual page 43

NOTE:
Skip steps 4–6 if the oil filter element is
not being replaced.
4. Remove the oil filter element cover
by removing the bolts.
1. Bolt
2. Oil filter element cover
5. Remove and replace the oil filter
element and O-ring.
PERIODIC MAINTENANCE AND MINOR REPAIR
1. Oil filter element
2. O-ring
6. Install the oil filter element cover by
installing the bolts, then tightening
them to the specified torque.
Tightening torque:
Oil filter element cover bolt:
7.0 Nm (0.7 m·kgf, 5.1 ft·lbf)
NOTE:
Make sure that the O-ring is properly
seated.
7. Install the engine oil drain bolt, and
then tighten it to the specified
torque.
6-8
Tightening torque:
Engine oil drain bolt:
34 Nm (3.4 m·kgf, 24 ft·lbf)
8. Add the specified amount of the
recommended engine oil, and then
install and tighten the oil filler cap.
Recommended engine oil:
See page 8-1.
Oil quantity:
With oil filter element replacement:
1.60 L (1.69 US qt) (1.41 Imp.qt)
Without oil filter element replace-
ment:
1.40 L (1.48 US qt) (1.23 Imp.qt)
CAUTION:
G
In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of "CD" or oils of a high-
er quality than specified. In
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
6
ECA11620