Pioneer SC-LX801 Basic Manual page 71

> Specifications > Settings
Setting Item Default Value
Height 2 Right 10' 0" / 3.00 m
Surround Left 10' 0" / 3.00 m
Surround Right 10' 0" / 3.00 m
Surr Back Left 10' 0" / 3.00 m
Surr Back Right 10' 0" / 3.00 m
Subwoofer 1 10' 0" / 3.00 m
Subwoofer 2 10' 0" / 3.00 m
• Default values vary depending on the regions.
• Distance units can be switched by pressing MODE on the remote controller. When the unit is set as
feet, you can set between 0' 0" 1/2 and 30' 0" in increments of 1/2. When the unit is set as meters,
> Listening Modes > Playback Function
Setting Details
The test pulse is output from this speaker and
the benchmark Front Right speaker, so adjust the
distance so the point where the test pulse is heard
is in the middle of the two speakers.
• Depending on the use of the ZONE speakers, it
may not be possible to select this setting.
The test pulse is output from this speaker and
the benchmark Front Left speaker, so adjust the
distance so the point where the test pulse is heard
is in the middle of the two speakers.
The test pulse is output from this speaker and
the benchmark Front Right speaker, so adjust the
distance so the point where the test pulse is heard
is in the middle of the two speakers.
The test pulse is output from this speaker and the
benchmark Surround Left speaker, so adjust the
distance so the point where the test pulse is heard
is in the middle of the two speakers.
• Depending on the use of the ZONE speakers, it
may not be possible to select this setting.
The test pulse is output from this speaker and the
benchmark Surround Right speaker, so adjust the
distance so the point where the test pulse is heard
is in the middle of the two speakers.
• Depending on the use of the ZONE speakers, it
may not be possible to select this setting.
The test pulse is output from this speaker and
the benchmark Front Left speaker, so adjust the
distance so the point where the test pulse is heard
is in the middle of the two speakers.
The test pulse is output from this speaker and the
benchmark Subwoofer 1, so adjust the distance
so the point where the test pulse is heard is in the
middle of the two speakers.
you can set between 0.01 m and 9.00 m in increments of 0.01 m.
> Basic Manual
Troubleshooting | Appendix
35