Adjusting The Center Rollers; Positioning The Seat - Toro Z149 Z Master 74411 Operator's Manual

Figure 20
1. Outer roller
2. Stud
3. Washer
Note: Do not remove the wheel nut and
washer (Figure 20).
4. Select a hole so that the outer roller is
positioned to the nearest corresponding
height-of-cut desired (Figure 20).
5. Install the stud nut and washer (Figure 20).
6. Repeat this adjustment on the other rollers.

Adjusting the Center Rollers

1. Disengage the PTO, move the motion control
levers to the neutral locked position, and set
the parking brake.
2. Stop the engine, remove the key, and wait for
all moving parts to stop before leaving the
operating position.
3. After adjusting the height-of-cut, remove the
bolt and nut (Figure 21).
4. Nut
5. Wheel nut and washer (do
not remove)
Figure 21
1. Center rollers and spacer
2. Nut
4. Select a hole so that the center rollers are
positioned to the nearest corresponding
height-of-cut desired (Figure 21).
Note: Do not adjust the rollers to support
the mower housing.
5. Install the bolt, center rollers, and nut
(Figure 21).

Positioning the Seat

The seat can move forward and backward.
Position the seat where you have the best control
of the machine and are most comfortable.
Important: To adjust, move the lever
sideways to unlock seat (Figure 22).
Slide the seat to the desired position and release
lever to lock in position.
Figure 22
1. Adjustment lever
21
3. Bolt