Pppoe (K-Ew214L01E, K-Ef234L01E) - Panasonic K-EW114L03AE Operation Manual

HTTPs
HTTPs
Port
4.3.3

PPPoE (K-EW214L01E, K-EF234L01E)

The PPPoE interface is shown as in Figure 4-16.
Input the PPPoE user name and password you get from the IPS (internet service provider) and enable
PPPoE function. Please save current setup and then reboot the device to get the setup activated.
Device connects to the internet via PPPoE after reboot. You can get the IP address in the WAN from
the IP address column. When PPPoE is on, please disable UPnP to avoid influence on dial-up.
Please note, you need to go to the IP address item to via the device current device information.
You can access the client-end via this address.
Set to enable HTTPS protocol.
The default value is 443. You can input the actual port number if
necessary.
Figure 4-11
42