Sequencer, Animator And Arpeggiator - M Modal Electronics 001 User Manual

05
Sequencer, Animator
and Arpeggiator
42
LFO Osc1
Wave/PW
Wave Rate
LFO-1 LFO-2
Note
PW Detune
Source Depth
LFO-1
LFO-2
Velo
AftT
DeRez Sync
Osc1 Wave1 Slope Drive
Key Mode
Poly Stack
Mono
Osc2 Wave2 VCF VCA
Keyboard
Glide
Modulation
Oct - Oct + Transpose
In this section we are going to explain three very important features of the Modal 001: first
of all, our very powerful 12 row, 32 step Sequencer; secondly, a unique tool called Animator,
a note-triggered sequencer for parameters that allow you to create complex modulations;
finally, the 001's Arpeggiator.
On the right hand side of the 001 front panel, the same set of controls are shared between
Envelope (see 'Envelope' section in chapter 3) and Sequencer/Animator/Arpeggiator
functionalities: to switch between the two modes, just press the EG/Seq button.
Before you continue reading this section, please make sure that the LED is in 'Seq' position.
To access the screen page related to one of these sections, you can either repeatedly press the
Seq/Ani/Arp panel button underneath the Tempo knob or use the second 'menu button' (B)
under the LCD..
This panel also features:
• the Tempo encoder, which can be turned to change the current Song Tempo (expressed
in BPM) and also tapped to start/stop the Sequencer
• Backward/Forward buttons, for changing the step position on the LCD/panel (both for the
Sequencer and the Animator)
• a Mode button, for changing the direction mode of the sequence/animation
• Up/Down buttons, for changing the two currently displayed rows on the LCD (both for
Seq/Ani). Please note that the front panel encoders edit the first displayed row (i.e. VCF-
EG Attack corresponds to the first step, Decay to the second step, etc.)
Osc2 Mix
Osc1 Osc2
Drive
Note
Sub1 Sub2
PW
SubWav
Recall
VCF
CutOff Decay
Attack
Slope Reso
EG Note
LFO-2 Velo Attack
Decay
EG
Tempo
Select
- +
Seq
Sequencer
VCF-EG
Sustain
Release
VCA-EG
Amount
Release
Sustain
Seq
Mode
Volume
Arp
Ani
43