Installation and connection
en
:
Warning
Children may lock themselves in the
dryer, putting their lives at risk!
Do not set up the dryer behind a door
or sliding door, as this may obstruct the
dryer door or prevent it from opening.
Caution!
Risk of injury
Due to the heavy weight of the dryer,
■
you may injure yourself if you lift it.
Do not lift the dryer on your own.
You could cut your hands on the
■
sharp edges of the dryer. Do not
hold the dryer by the sharp edges.
Protruding parts on the dryer may
■
break off when it is lifted or pushed.
Do not move the dryer by holding
onto protruding parts.
Caution!
Risk of material damage to the dryer or
fabrics.
Check the dryer for damage caused
■
during transportation. Never operate
a dryer if it is damaged.
Any residual water in the dryer may
■
freeze and damage the dryer. Do not
install the dryer in rooms that are at
risk of frost.
During installation, ensure that:
The dryer is placed on a clean, level
■
and firm surface,
The mains plug can be accessed at
■
all times,
The air inlet on the dryer is kept clear
■
and there is sufficient ventilation,
The area around the dryer is kept
■
clean and
The dryer is levelled using the
■
threaded feet. Use a spirit level to do
this.
28
Changing the condensation
drain
Notes
The condensation from the dryer can
■
either be discharged into the
condensate container or drained off
via a connection to the waste-water
system. At the factory, the
condensation from the dryer is
discharged into the condensate
container.
If the condensation drain is installed,
■
residual water remains in the
condensate container because of
the dryer's self-cleaning function.
Change the condensation drain as
follows:
Remove the accessory from the
1.
dryer drum.
Delivery status of the dryer. The hose
2.
for discharging the condensation
into the condensate container is
secured to the connecting piece.
Disconnect the hose from the
3.
connecting piece and move it into
the "parked" position.
Need help?
Do you have a question about the WTW87560GB and is the answer not in the manual?
Questions and answers