1. Plug the gray cable into the connector labeled MAIN or 1 on the card; and plug the black cable into the
connector labeled AUX or 2 on the card.
2. Ensure that the wireless-LAN cables are routed as shown. When you route the cables, install the
cables to the hook, and then insert the wireless-LAN cables into the hinge. However, do not pull the
wireless-LAN cables from the hinge.
3. When you route the cables, ensure that there is a gap between the wireless-LAN cables and the hinge.
1070 M.2 solid-state drive
For access, remove this FRU:
•
"1020 Base cover assembly" on page 58
.
Chapter 9
Removing or replacing a FRU
67