Table of Contents
Advertisement
Menu Items
COMMUNICATION SETTING
LAN SETUP
Configures the settings to control the monitor from the computer via LAN. (See page 36.)
IP CONTROL SETUP
To control the monitor from a computer via LAN, set this to ENABLE and configure the login ID and other settings. (See page 37.)
nMONITOR
MONITOR
Selects the installation direction of the monitor.
LANDSCAPE ............Landscape orientation
PORTRAIT ...............Portrait orientation. MULTIMEDIA (see page 20) always remains in landscape orientation.
* If video is upside down when the monitor is installed in the portrait orientation, you can rotate the video 180 degrees with
PORTRAIT ROTATE (see page 30) in the FUNCTION menu. When this is done, the MONITOR setting cannot be changed.
POWER SAVE MODE
When OFF is selected, startup time from standby mode is reduced. Note, however that, more power will be consumed in
standby mode.
When ON is selected, current consumption is reduced while the monitor is in standby mode. Note, however, that the startup
time from standby mode becomes longer.
If set to ON, control via LAN cannot be performed in standby mode.
If set to ON, INPUT SIGNAL ON is set to NO.
OFF IF NO OPERATION
Set whether or not the monitor goes into standby mode when there is no operation from the remote control or RS-232C / LAN.
After setting this to YES, set the standby mode entry time. The entry time can be set to a maximum of 12 hours in increments
of 1 hour.
OFF IF NO SIGNAL
Sets whether or not the monitor enters the standby mode when there is no input signal for more than 5 minutes. When INPUT
SIGNAL ON is YES, the monitor changes to the input signal waiting mode. When INPUT SIGNAL ON is NO, the monitor
changes to the standby mode.
If set to OFF, INPUT SIGNAL ON is set to NO.
INPUT SIGNAL ON
Set whether or not the monitor automatically recovers from the input signal waiting mode.
When this is set to YES and the monitor is in the input signal waiting mode, the power turns on (the power "on" state is entered)
when a signal is input into the currently selected terminal.
If set to YES, POWER SAVE MODE automatically changes to OFF and OFF IF NO SIGNAL automatically changes to ON.
(The factory default setting for POWER SAVE MODE is ON. The factory default setting for OFF IF NO SIGNAL is OFF.)
When this is YES and POWER SAVE MODE is changed to ON or OFF IF NO SIGNAL is changed to OFF, INPUT SIGNAL ON
automatically changes to NO.
If POWER SAVE MODE is set to OFF, more power will be consumed in standby mode than when set to ON.
nOTHERS
MULTIMEDIA AUTOPLAY
Sets the media used for auto play. (See page 22.)
SOFTWARE VERSION
Shows the software version, etc.
SOFTWARE UPDATE
You can update the software.
SETTING RESET
Resets the settings to factory default settings.
* Photo files copied to INTERNAL MEMORY with MULTIMEDIA will not be erased.
28
E
Advertisement
Table of Contents
